Flomec TM Series - Operation and Calibration; Adjusting Zero and Span

To Next Page

To Previous Page

OPERATION / CALIBRATION

Adjusting ZERO and SPAN

To set or adjust ZERO and SPAN settings, refer to the Q9 Owner’s Manual (Non-Agency)

Configuration Mode (Daughter Board Options) and Calibration Mode Section for further

instructions.

NOTE: The Q9 Display controls the 4-20 mA settings. It is recommended to verify and set

(if necessary) the most optimal Calibration Method of the Q9 Display (see Q9 Owner’s

Manual referenced above) before adjusting 4-20mA settings.

You can download the Q9 Owner’s Manual (Non-Agency) here:

or visit flomecmeters.com to download owner’s manuals and other technical documents.

Other manuals for Flomec TM Series