Flowserve FLEX 6300 - 11 Technical Data; Equipment Dimensions and Weights; Nameplate; Operating Limits

FLEX User Instruction – 21TEM14546 EN
Page 36 of 43
11 Technical Data
11.1 Equipment dimensions and weights
Approximate weights are shown in Table 7. For exact dimensions and weights of the product
ordered, refer to the general arrangement drawing included upon receiving the product.
Table 7: Equipment dimensions and weights
DESCRIPTION
UNITS
FLEX 6300
FLEX 8600
Dry weight
kg (lb)
29 (63)
72 (158)
Wet weight
kg (lb)
33 (73)
83 (182)
Port size (nominal diameter)
---
3 inch
4 inch
LP port spacing (end-to-end)
mm (in)
533.4 (21.00)
762.0 (30.00)
HP port spacing (center-to-center)
mm (in)
444.5 (17.50)
635.0 (25.00)
Port offset (HP face to LP center)
mm (in)
152.4 (6.00)
203.2 (8.00)
11.2 Nameplate
Figure 16: Nameplate
11.3 Operating limits
Table 8: Operating limits
DESCRIPTION
UNITS
FLEX 6300
FLEX 8600
Maximum Flow
m
3
/h (gpm)
68 (300)
136 (600)
Minimum Flow
m
3
/h (gpm)
34 (150)
68 (300)
Maximum Low Pressure
bar (psi)
18 (260)
12 (180)
Maximum High Pressure
bar (psi)
83 (1,200)
Minimum Backpressure
bar (psi)
1.0 (15)
Maximum Temperature
°C (°F)
50 (120)
Maximum Filter Size
µm (mils)
20 (0.8)
Model
Product of the USA
HP Connection Date of Construction
LP Connection Job N°
min max Serial N°
bar Material
psi
m3/h Rated Capacity [m³/h]
gpm Rated Pressure HP in [bar]
AllowableTemperature °C Rated Pressure LP out [bar]
Weight Dry kg
Rated Temperature [°C]
Allowable Pressure
Project Rating
Allowable Flow
ISO 9001 Certificate