FLEX User Instruction – 21TEM14546 EN
Page 5 of 43
1.3 Certification instruction
It is a legal requirement that machinery and equipment put into service within certain regions of
the world shall conform to the Marking Directives applicable to Flowserve products (i.e.,
Machinery Directive, Low Voltage Directive, Electromagnetic Compatibility (EMC) Directive,
Pressure Equipment Directive (PED), Equipment for Potentially Explosive Atmospheres (ATEX),
etc.).
Certificates defined in the Contract requirements are provided with these instructions where
applicable. Examples of the certificates can be found in the Annex of this document. If required,
copies of other certificates sent separately to the Purchaser should be obtained from the
Purchaser for retention with this User Instruction.
1.4 Units
This document uses dual ISO and US units.
To Next Page
Loading...
