Logix™ 3800zb Digital Positioner FCD AIIOM001030_EN 02/23
flowserve.com 28
10.7 Hot Keys
Hot keys are button combinations used to quickly access
different features. They are available to press when the LCD
screen is showing the Main view. See Table 4: Hot Keys. or
for more detailed instruction, see Appendix F – Hot Keys.
Table 4: Hot Keys
Clear PST fail error message
(Hold III for 3 Sec, then briefly press II)
*A full calibration (Quick-Cal with other diagnostic
evaluations) will run the first time, if a full calibration has not
been completed.
10.8 Viewing Version Numbers (No LCD)
The firmware version numbers may be checked at any time
except during a calibration. To see the version number, hold
the and the buttons for 3 seconds. Then briefly press
the button too see the major version and the button
for minor version number. The codes are in a 3-blink
sequence. The sequence corresponds to a number as shown
in Table 5: Version Number Codes.
To exit the version viewing mode, briefly press the button.
This will not alter the operation of the positioner.
Table 5: Version Number Codes
To Next Page
Loading...
Need help?
General
