flsun SR - Load Filament

Load Filament
1. Straighten the
end of the filament
10cm. Use diagonal
pliers to cut the
end of the filament
into a bevel
2. This is how the
filament should
look after cutting
3. Push the
filament through
the PTFE tube in
the top shell
4. Push the filament
through the filament
detection sensor and
insert it into the
extruder
5. Turn on the power
6. Click “Tools” on
the homepage
7. Click “Change”
8. Click the
white input
box
9. If you use PLA
please enter 200
and click “OK”