12. Set the printing temperature of the nozzle, when printing PLA, due to the high speed
the nozzle temperature should be set to 220°C.
13. Set the printing temperature of the hot bed.
14. Enable retraction, to avoid stringing or oozing during printing.
15. Set the printing speed, the default printing speed of SR is 150mm/s, and the
maximum printing speed is 200mm/s.
16. Whenever a retraction is done, the build plate is lowered to create clearance
between the nozzle and the print. It prevents the nozzle from hitting the print during
travel.
17. Turn on the turbo fan. When printing a smaller model, turn on the turbo fan to
prevent the model from warping.
18. Set the fan speed.
19. Enable generate support.
20. Support placement style, “Everywhere” means that support is not only generated
from the hot bed, but also from the model itself, “Touching Buildplate” means the
support will be generated only from the hot bed.
21. Support will be generated only when the angle between the model and the vertical
direction is greater than this degree.
22. Build plate adhesion type. Select “Brim” mode to make the model better stick to the
hot bed.
appropriate
parameters, click
Removable driver”
card into the
printer card
To Next Page
Loading...
