Fluidmaster PerforMAX - Step 3: Adjust Height of New Fill Valve; Adjust Fill Valve Height

STEP 2: REMOVE OLD FILL VALVE
5
STEP 3: ADJUST HEIGHT OF NEW FILL VALVE
A: TWIST FILL VALVE TO ADJUST HEIGHT
Top of fill valve cap should measure roughly 3"
above top of overflow pipe when installed.
TWIST
LEFT
NOTE:
Increasing height allows
more water to fill in the tank.
HOLD
Do Not Move Lock Ring
*
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
TOP OF FILL VALVE CAP
TOP OF OVERFLOW PIPE
3"
Fill Valve Cap
Overflow Pipe
*Lever Hole