Fluidwell E018 Tutorial

E110-SERIES TUTORIAL AUTOMATIC UNIT CONVERSION
FW_E110_AutoUnitConv_002_EN Page 3
Table of content
1 DESCRIPTION OF THE AUTOMATIC UNIT CONVERSION ................................................ 4
1.1 The relation between the K-Factor and the automatic unit conversion ................................... 4
1.2 The relation between the K-Factor and the measurement unit set by hand ............................ 4
2 HOW TO SETUP THE AUTOMATIC UNIT CONVERSION ................................................... 5
2.1 How to set the K-Factor (units) for the flowmeter ................................................................... 5
2.1.1 The automatic unit conversion - AUTO-VOL and AUTO MAS mode ...................................................... 5
2.1.2 The automatic unit conversion - HAND mode ......................................................................................... 7
2.2 Set the reading for the (accumulated) total ............................................................................. 7
2.2.1 The (accumulated) total - AUTO-VOL and AUTO MAS mode ................................................................ 7
2.2.2 The (accumulated) total - HAND mode ................................................................................................... 9
2.3 Set the reading for the flow rate ........................................................................................... 10
2.3.1 The flow rate - AUTO-VOL and AUTO MAS mode ............................................................................... 10
2.3.2 The flow rate - HAND mode................................................................................................................... 12

Fluidwell E018 Specifications

General

Brand	Fluidwell
Model	E018
Category	Measuring Instruments
Language	English