Calibrator
Remote Commands
45
Table 23. Oscilloscope Commands
Commands Description
OL_TRIP? Returns the detected state of scope overload protection.
OUT_IMP Set the output impedance of the SCOPE BNC.
OUT_IMP? Returns the output impedance of the SCOPE BNC.
RANGE Set the Calibrator range when in PULSE or MEASR scope modes.
SCOPE Set the Calibrator output to an oscilloscope mode.
SCOPE? Returns the present oscilloscope mode.
TLIMIT Set the time limit for Scope Option OVERLD mode to stay in operate.
TLIMIT? Returns the time limit for Scope Option OVERLD mode to stay in operate.
TLIMIT_D
Set the power-up and reset default for the time limit for Scope Option OVERLD
mode to stay in operate.
TLIMIT_D?
Returns the power-up and reset default for the time limit for Scope Option
OVERLD mode to stay in operate.
TMWAVE Selects the waveform for MARKER mode.
TMWAVE? Returns the timemark waveform setting for MARKER mode.
TRIG Set the frequency of the signal at the TRIG OUT BNC.
TRIG? Returns the frequency of the signal at the TRIG OUT BNC.
VAL?
Returns the last thermocouple, or, for the Scope Option, impedance measurement
value.
VIDEOFMT Selects the format for VIDEO mode.
VIDEOFMT? Returns the VIDEO mode format.
VIDEOMARK Set the VIDEO mode line marker location.
VIDEOMARK? Returns the VIDEO mode line marker location.
ZERO_MEAS Set the zero offset for capacitance measurement with the Scope Option.
ZERO_MEAS? Returns the zero offset for capacitance measurement with the Scope Option.
To Next Page
Loading...
