Fluke 123B - Page 27

96 pages

To Next Page

To Previous Page

Industrial ScopeMeter®

Scope and Meter Mode

hxv04.eps

Figure 8. Correct Grounding Setup

Main Page

Table of Contents3
List of Figures9
Introduction11
How to Contact Fluke11
Safety Information11
Symbols14
Test Tool Kit Contents15
Get Started17
- Battery Pack17
- Mains Power Source18
- SD Memory Cards18
Test Tool Setup19
- Reset the Test Tool19
- Screen Brightness20
- Menu Selection20
- Measurement Connections21
- Measurement Probe Setup21
- Tilt Stand22
- Hanger22
- Language Selection22
Scope and Meter Mode23
- How to Read the Screen24
- Connect-And-View25
- Measurements25
- Inputs29
- Intellaset™ / Autoreading29
- Measurement Type30
- Screen Freeze31
- How to Hold a Stable Reading31
- Relative Measurements32
- Auto Range/Manual Range33
- Screen Graphic Adjustment33
- Waveform Acquisition37
- Waveform Trigger39
  - Set Trigger Level and Slope39
  - Select Trigger Parameters40
- Cursor Measurements42
  - Horizontal Cursors42
  - Vertical Cursors43
- Rise Time Measurements44
- High Frequency Measurements with 10:1 Probe45
  - Probe Attenuation45
  - Probe Adjustment45
Power and Harmonics Mode45
- Volts/Amps/Watt Measurements46
Volt/Amp Readings47
- Harmonics Measurements48
Harmonics Voltage Measurements49
Harmonics Current Measurements50
Harmonics Power Measurements51
- Zooming Harmonics52
Fieldbus Mode52
Bus Measurement Inputs53
- How to Read the Screen54
Test Signal Properties55
Bus Test Screen Indicators56
- How to View the Bus Waveform Screen57
- Test Limits58
Recorder Mode59
- Start and Stop Meter Recording60
- Cursor Measurements62
- Zoom In/Out on Logged Meter Data63
- Events63
- Scope Record Mode63
Save and Recall Data Sets65
- Test Sequence66
- Setting Recall67
- Data Set Management67
- Waveform Comparison68
Communication69
- Optical Interface69
- Wireless Interface69
Maintenance71
- How to Clean71
- Storage71
- Battery Replacement71
- 10:1 Scope Probes72
- Calibration Information73
Replaceable Parts and Accessories75
Optional Accessories76
Tips77
- Battery Life77
- Power off Timer77
- Autoset Options78
- Grounding Guidelines78
Specifications79
- Dual Input Oscilloscope79
- Dual Input Meter81
- Cursor Readout (124B, 125B)88
- Recorder89
- Power Quality (125B)90
- Field Bus Measurements (125B)91
- Miscellaneous92
- Environmental93

Fluke 123B - Page 27

Table of Contents

Related product manuals