Fluke 1777 - Verification

1773/1775/1777
Calibration Manual
12
Verification
The Verification and Adjustment sheets are the built-in procedures. See Ta bl e 7 .
Table 7. Calibration
Item Description

Verification items: For a complete instrument verification all of these items
must be verified in successive tests: Voltage, Voltage Transient, Current,
and AUX. A specific order is not required. Completed items are shown with
a check mark.

Result: Status of the verification items. After performing the verification,
the result of each item shall be PASS. FAIL indicates a deviation outside the
tolerance limits.

Start: Start of the verification for the selected item.

Status: Log of the verification process. This information is also stored in a
log file.
1
2
3
4