15B & 17B
Users Manual
2
XWWarning
To prevent possible electrical shock, fire, or
personal injury:
• Read all safety Information before you
use the Product.
• Carefully read all instructions.
• Examine the case before you use the
Product. Look for cracks or missing
plastic. Carefully look at the insulation
around the terminals.
• Do not use and disable the Product if it
is damaged.
• Do not use the Product if it operates
incorrectly.
• Do not touch voltages > 30 V ac rms, 42
V ac peak, or 60 V dc.
• Limit operation to the specified
measurement category, voltage, or
amperage ratings.
• Use the Product only as specified, or the
protection supplied by the Product can
be compromised.
• Replace the batteries when the low
battery indicator shows to prevent
incorrect measurements.
• Comply with local and national safety
codes. Use personal protective
equipment (approved rubber gloves, face
protection, and flame-resistant clothes)
to prevent shock and arc blast injury
where hazardous live conductors are
exposed.
• Do not apply more than the rated voltage,
between the terminals or between each
terminal and earth ground.
• Measure a known voltage first to make
sure that the Product operates correctly.
• Use the correct terminals, function, and
range for measurements.
• Do not use the Product around explosive
gas, vapor, or in damp or wet
environments.
• Do not use test leads if they are
damaged. Examine the test leads for
damaged insulation, exposed metal, or if
the wear indicator shows. Check test
lead continuity.
To Next Page
Loading...
Need help?
General
