Clamp Meter
Safety Information
3
• Use caution around bare conductors or bus bars. To prevent
electrical shock, do not touch the conductor.
• Comply with local and national safety codes. Use personal
protective equipment (approved rubber gloves, face
protection, and flame-resistant clothes) to prevent shock
and arc blast injury where hazardous live conductors are
exposed.
• Disconnect power and discharge all high-voltage capacitors
before you measure resistance or continuity.
• Do not measure ac/dc current in circuits carrying more than
600 V or 200 A with the Product Jaw.
• Do not operate the product with covers removed or the case
open. Hazardous voltage exposure is possible.
• When white wear indicator insulation shows through the
clamp cable jacket, replace the clamp cable.
• Do not exceed the Measurement Category (CAT) rating of
the lowest rated individual component of a product, probe,
or accessory.
• Measure a known voltage first to make sure that the Product
operates correctly.
W Caution
To prevent possible damage to the product or to equipment
under test:
• Use the correct terminals, function, and range for
measurements.
• Clean the case and accessories with a damp cloth and mild
detergent only. Do not use abrasives or solvents.
To Next Page
Loading...
