Fluke 6100B - Page 127

Remote Operation
SCPI Commands and Syntax 5
5-23
Keyword Parameter Form Notes
:SHAPe(?) <cpd> { RECTangular | SINusoidal | SQUare }
:DUTY(?) <dnpd>
:EFLicker
[:STATe](?) <bool> { OFF | ON | 0 | 1 }
:CONFigure(?) <cpd> { PF | MZ | HS | PJ | RV }
:SPERiod(?) <cpd> { OFF | S5 | S10 | M1 | M5 | M10 }
:HSIDeband
:HARMonic(?) <dnpd>
:PJUMp
:ANGLe(?) <dnpd> Only +/- 30.0 and +/- 45.0
accepted.
:STAGe?
:ELAPsed? Query Only command
<dnpd>,<dnpd> = minute, second
:CURRent
[:STATe](?) <bool>{OFF|ON|0|1}
:RANGe <dpnd>, <dpnd> <dnpd> = low limit, high limit
:RANGe? [<cpd>{ LOW | HIGH }]
:VOLTage <dpnd>, <dpnd> <dnpd> = low limit, high limit
:VOLTage(?) [<cpd>{ LOW | HIGH }]
:UNIT? Response is VOLT (voltage) or
CURR (current).
Query only.
:EQUivalence
[:STATe](?) <bool>{OFF|ON|0|1}
:FACTor(?)
<dnpd>
:TERMinal
:ROUTe(?) <cpd>{ UPPer | LOWer } Only applicable when the 50A
option is fitted
:AMPLitude? Absolute final output amplitude.
Query only.
:BANDwidth(?) [<cpd>{NORMAL | LOW}]
:MHARmonics
[:STATe](?) <bool>{OFF|ON|0|1}
:CLEar
:AMPLitude(?) <dnpd> <dnpd> = RMS amplitude.
:HARMonic<y> <dnpd>,<dnpd> <y> is harmonic number.
<dnpd> = Amplitude, Phase.
Note: amplitude absolute or %
depending on value of
UNIT:MHAR:...