Fluke 700G Series - How to Change the Batteries

700G Series
Calibration Manual
8
How to Change the Batteries
Warning
To prevent possible electrical shock, fire, or personal injury,
batteries must only be changed in an area known to be non-
hazardous. Explosion hazard.
To change the batteries, see Figure 1:
1. Remove the Product holster.
2. Use a Phillips screwdriver to loosen the captive screw on the battery door.
3. Remove the battery door.
4. Replace the three AA batteries.
5. Install the battery door again.
6. Tighten the captive screw.
7. Put the Product back into the holster.
+
-
-
gvv002.eps
Figure 1. How to Change the Batteries