RTD Calibrator
Step and Ramp Modes
23
Step and Ramp Modes
Select Step or Ramp Mode
The Product allows you to set Step and Ramp modes for
easier check of points within the linear range in output
mode.
To set the Step or Ramp mode:
1. Push .
2. Use and to select Step mode and Ramp mode.
The or icon shows on the Product display
accordingly.
Note
This function is only available when Source
mode is selected.
Auto Storage of Settings
The Product automatically stores the latest settings,
including the temperature unit, the linear range of mA
converting to temperature, and sensor type.
Every time you turn on the Product, it automatically
applies the last settings.
To Next Page
Loading...
Need help?
General
