7341
Users Guide
13-6
Comments
EMC Directive
Fluke’s equipment has been tested to meet the European Electromagnetic Compatibility
Directive (EMCEMC Directive, 89/336/EEC). The Declaration of Conformity for your
instrument lists the specific standards to which the unit was tested.
The instrument was designed specifically as a test and measuring device. Compliance to
the EMC directive is through EN 61326-1:2006 Electrical equipment for measurement,
control and laboratory use – EMC requirements.
This instrument was tested to Criteria A immunity requirements for Controlled EM
Environments per EN61326-2-1:2006 for EM Field from 0.8-2.7 GHz.
As noted in the IEC 61326-1, the instrument can have varying configurations. The
instrument was tested in a typical configuration with shielded RS-232 cables.
Immunity Testing
The instrument was tested for laboratory locations. Criterion B was used for Radiated RF
(IEC 61000-4-3) and Voltage dips, short interruptions, as well as voltage immunity tests
(IEC 61000-4-11). Criterion C was used for Electrostatic Discharge (ESD, IEC 61000-4-2).
If the instrument is subjected to ESD conditions, the instrument may require the user to
cycle the power to return to normal operation.
Emission Testing
The instrument fulfills the limit requirements for Class A equipment but does not fulfill
the limit requirements for Class B equipment. The instrument was not designed to be
used in domestic establishments.
Low Voltage Directive (Safety)
In order to comply with the European Low Voltage Directive (73/23/EEC), Fluke
equipment has been designed to meet the following standards:
• IEC 1010-1 (EN 61010-
1)
• IEC 1010-2-
010 (EN 61010-2-01
0)
Via Acquanera, 29 22100 Como
tel. 031.526.566 (r.a.) fax 031.507.984
info@calpower.it www.calpower.it
To Previous Page
Loading...