7526A
Calibration Manual
2
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user. A
Caution identifies conditions and procedures that can cause damage to the Product or
the equipment under test.
Warnings
To prevent possible electrical shock, fire, or personal injury:
• Read all safety Information before you use the Product.
• Carefully read all instructions.
• Use the Product only as specified, or the protection
supplied by the Product can be compromised.
• Use this Product indoors only.
• Examine the case before you use the Product. Look for
cracks or missing plastic. Carefully look at the insulation
around the terminals.
• Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
• Replace the mains power cord if the insulation is damaged
or if the insulation shows signs of wear.
• Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
• Do not put the Product where access to the mains power
cord is blocked.
• Do not touch voltages >30 V ac rms, 42 V ac peak, or
60 V dc.
• Use only cables with correct voltage ratings.
• Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
• Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
• Remove all probes, test leads, and accessories that are not
necessary for the measurement.
• Do not use the Product if it operates incorrectly.
• Do not use and disable the Product if it is damaged.
To Next Page
Loading...
