Documenting Process Calibrator
Measure Mode
41
gks14f.eps
Figure 16. Correct Jumper Use
8. If necessary, change between °C, °F, K, and °R
temperature units in Setup:
1. Push s.
2. Push the Next Page softkey twice.
3. Push and to move the cursor to
Temperature Units.
4. Push or the Choices softkey to choose a
setting for that parameter.
5. Push or to move the cursor to the necessary
setting.
6. Push to go back to the s display.
7. Push the Done softkey or s to exit Setup mode.
9. If necessary, change between ITS-90 or IPTS-68
Temperature Scale in Setup mode. The procedure is
the same as steps 1-7 above.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca
To Next Page
Loading...
