789
Product Overview
18
Power-Up Options
To select a power-up option, hold down the pushbutton
shown in Table 8 while turning the rotary function switch
from OFF to any on position. Wait 2 seconds before
releasing the pushbutton after powering up the meter.
The meter beeps to acknowledge the power-up option.
Only the setting for current span is retained when the
power is turned off. The other options have to be
repeated for each operating session.
Holding down more than one pushbutton can activate
more than one power-up option.
Table 8. Power-Up Options
Option Pushbutton Default Action Taken
Change current span 0 % setting R Remembers
last setting
Toggles between 0 - 20 mA and 4 - 20 mA
range
Disable beeper G Enabled Disables beeper
Disable auto power-off
J
(Blue)
Enabled Disables the feature that turns off the
meter power after 30 minutes of inactivity.
Auto power off is disabled regardless of
this option if MIN MAX recording is on.
Display test/show firmware version H Disabled Display HOLD (as long as button is
pushed), then shows firmware version.
To Next Page
Loading...
