ProcessMeter
General Maintenance
19
General Maintenance
Periodically wipe the case with a damp cloth and
detergent; do not use abrasives or solvents.
Replacing the Batteries
! Warning
To avoid electrical shock:
• Remove test leads from the meter before
opening the battery door.
• Close and latch the battery door before
using the meter.
Replace the batteries as follows. Refer to Figure 7. Use
four AA alkaline batteries.
1. Remove the test leads and turn the meter OFF.
2. With a standard blade hand screwdriver, turn each
battery door screw counterclockwise so that the slot is
parallel with the screw picture molded into the case.
3. Lift off the battery door.
4. Remove the meter's batteries.
5. Replace with four new AA alkaline batteries.
6. Reinstall the battery door and tighten screws.
To Next Page
Loading...
