Fluke 8600A - Page 68

8600A
Figure
6-2.
MODEL C86 CARRYING CASE
6-12.
Installation Procedure
6-13.
Installation instructions for each of the rack
mounting kits is given
in
the following paragraphs. Use
the procedure which
corresponds to
the
model number of
the
kit
being
installed.
6-14.
OFFSET
AND
CENTER MOUNTING KITS
(M00-200-61 1
and M00-200-612)
a.
Remove
8600A carrying handle by removing
the
handle disc decals
and
the handle mounting screws.
b.
Remove
screw
from
rear of case and separate the
case from
the 8600A.
c.
Install
the side mounting
brackets,
as
shown
in
Figure
6-3
,
and secure them to the mounting panel
using the nuts provided.
d.
Insert
the
front of the 8600A case
through the
opening
on the back side
of the
mounting panel.
e. Install
the handle mounting screws
through
the
side
brackets
into the
handle mounting bosses.
Don’t
over tighten
these
screws.
f.
Slide the 8600A
through the
mounting panel
and
into
the case. Install and tighten the retaining
screw
at the rear of the case.
6-15. SIDE-BY-SIDE
MOUNTING KIT
(M00-200-613)
a.
Remove
the carrying
handles from both
8600A’s
by
removing
the
handle disc decals
and
the
handle
mounting screws.
b.
Remove the retaining
screw from the rear of
the
cases and separate
the instruments
from their
cases.
c. Install the center
mounting bracket,
as shown in
Figure
64,
and secure
it
to
the mounting panel
using the nuts
provided.
d. Install
the
clamp
screw
in the center mounting
bracket using the nuts
and washers provided.
e.
Insert the front of
the 8600
A
cases through the
openings on the
back side of the mounting panel.
Make sure the
case’s
handle mounting bosses are
inserted
into the clamp
hole of the center
mount-
ing bracket
f.
Tighten the
clamp screw.
g.
Install the side mounting
brackets and secure them
to the front
panel
using
the nuts
provided.
h. Install
the handle
mounting screws
through
the
side brackets
into the handle
mounting bosses.
Don’t
over
tighten these screws.
Slide the
8600A’s through the mounting
panel and
into their
cases. Install and tighten the retaining
screw
at
the
rear of both cases.
Table
6-1.
RACK MOUNTING
KITS
MOUNTING STYLE MODEL NUMBER
Offset
Center
Side-By-Side
MOO-200-61
1
M00-200-612
M00-200-613
6-16.
DELUXE TEST
LEAD KIT (A80)
6-17. The deluxe test lead kit, shown
in Figure
6-5,
contains two test leads with probes
(red and
black), and
five
pairs
of universal probe tips.
The probe
tips include
:
alligator clips, test prod tips, pin tips, banana plug tips, and
binding
post lugs.
A
convenient plastic pouch is
provided
for storing the contents of the test
lead
kit.
6-2