Fluke 9142 - Input Setup (-P Only); Figure 15 Main Menu - Input Setup

914X Field Metrology Wells
Input Setup (-P only)
32
4.4 Input Setup (-P only)
Figure 15
9142/9143/9144 MAIN MENU
F1 F2 F3 F4
TEMP SETUP PROG MENU SYSTEM MENU INPUT SETUP (-P only)
F1 SELECT INPUT
SENSOR TYPE: <RTD, TC, mA> <select>
F2 SETUP INPUT
F1 RTD SETUP
WIRES: <4, 2, 3> <select>
RTD TYPE: <RESISTANCE, PT100(385), PT100(3926), PT100(JIS), NI-120> <select>
F2 TC SETUP
TC TYPE: <K, L, M, N, R, S, T, U, mV, C, E, J> <select>
F3 mA SETUP
LOOP POWER: <DISABLE, ENABLE 24V> <select>
F4 TEST uut CALCulation
SENSOR TYPE: <RTD, TC> <select>
INPUT: <edit> <ohms if RTD, mV if TC is selected>
TEMPerature: <calculated value displayed> <view only>
F3 REFerence INPUT
F1 PROGram PROBE
SERIAL number: <edit> <alphanumeric>
CALibration DATE: <edit>
PROBE TYPE: <ITS-90, CVD, IEC-751, RESISTANCE> <select>
List:
ITS-90 CVD IEC751 RESISTANCE
RTPW R0
A ALPHA
B BETA
C DELTA
A4
B4
PROGRAM probe
<YES, NO> <password required to program probe>
F2 TEST reference CALCulation
RESISTANCE: <edit>
TEMPERATURE: <calculated value displayed> <view only>
Main Menu - Input Setup