Fluke 9142 - 1.2 Unpacking

914X Field Metrology Wells
Unpacking
2
sensors and devices. Before use, the user should be familiar with the warnings, cautions, and
operating procedures of the calibrator as described in the User’s Guide.
1.2 Unpacking
Unpack the instrument carefully and inspect it for any damage that may have occurred during
shipment. If there is shipping damage, notify the carrier immediately.
Verify that the following components are present:
9142

9142 Field Metrology Well

9142-INSX Insert (X=A, B, C, D, E, or F)

Power Cord

RS-232 Cable

User Guide

Technical Manual CD

Report of Calibration and calibration label

6-pin DIN Connector (-P model only)

Test Lead Kit (-P model only)

Well Insulator

Clamp-on ferrites (3) [-P model only]

Tongs (insert removal tool)

9930 Interface-it Software and User’s Guide
9143

9143 Field Metrology Well

9143-INSX Insert (X=A, B, C, D, E, or F)

Power Cord

RS-232 Cable

User Guide

Technical Manual CD

Report of Calibration and calibration label

6-pin DIN Connector (-P model only)

Test Lead Kit (-P model only)

Clamp-on ferrites (3) [-P model only]

Tongs (insert removal tool)

9930 Interface-it Software and User’s Guide