917X Series Metrology Wells
Getting Started
• Power Cord
• RS-232 Cable
• Getting Started Guide
bration and calibration label
d User’s Guide
9173
• 9173 Metrology Well
, B, C, D, E, or F)
Guide
calibration label
ser’s Guide
Service Center.
Setup
te: The instrument will not heat, cool, or control until the “CONT ENABLE” parameter is set to
“On.” Refer to Set-Point Setup on page 16 to set this parameter.
pace around the instrument.
Overhead clearance is required. DO NOT place under a cabinet or structure.
inal voltage
easily. Sleeves of various sizes are
s, dirt
• User's Guide
• Report of Cali
• DIN Connector (-R units only)
• Tongs (insert removal tool)
• 9930 Interface-it Software an
• 9173-INSX Insert (X=A
• Power Cord
• RS-232 Cable
• Getting Started
• User's Guide
bration and
• Report of Cali
• DIN Connector (-R units only)
Tongs (insert removal tool)
•
•
9930 Interface-it Software and U
If all items are not present, contact an Authorized
No
Place the calibrator on a flat surface with at least 6 inches of free s
Plug the Metrology Well power cord into a mains outlet of the proper voltage, frequency, and
current capability (see Specifications for power details). Observe that the nom
corresponds to that indicated on the back of the calibrator.
Carefully insert the probe sleeve into the well. Probe sleeves should be of the smallest hole
diameter possible still allowing the probe to slide in and out
available from Fluke’s Hart Scientific Division. The well must be clear of any foreign object
and grit before the sleeve is inserted. The sleeve is inserted with the two small tong holes
positioned upward.
14
To Next Page
Loading...
Need help?
General
