EasyManuals Logo

Fluke 917 Series User Manual

Fluke 917 Series
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
917X Series Metrology Wells
Setup
14
Getting Started Guide
Users Guide
Report of Calibration and calibration label
DIN Connector (-R units only)
Tongs (insert removal tool)
9173
9173 Metrology
Well
9173-INSX Insert (X=A, B, C, D, E, or F)
Power Cord
RS-232 Cable
Getting Started Guide
Users Guide
Report of Calibration and calibration label
DIN Connector (-R units only)
Tongs (insert removal tool)
If all items are not present, contact an Authorized Service Center.
3.2 Setup
NOTE: The instrument will not heat, cool, or control until the “CONT
ENABLE” parameter is set to “On.” Refer to Set-Point Setup on page 16 to set
this parameter.
Place the calibrator on a at surface with at least 6 inches of free space around the in-
strument. Overhead clearance is required. DO NOT place under a cabinet or structure.
Plug the Metrology Well power cord into a mains outlet of the proper voltage, fre-
quency, and current capability (see Specications for power details). Observe that the
nominal voltage corresponds to that indicated on the back of the calibrator.
Carefully insert the probe sleeve into the well. Probe sleeves should be of the small-
est hole diameter possible still allowing the probe to slide in and out easily. Sleeves
of various sizes are available from Fluke Calibration. The well must be clear of any
foreign objects, dirt and grit before the sleeve is inserted. The sleeve is inserted with
the two small tong holes positioned upward.
Turn on the power to the calibrator by toggling the switch on the power entry module.
After a brief self-test, the controller should begin normal operation. The main screen
will appear within 30 seconds. If the instrument fails to operate, please check the
power connection.
The display will show the well temperature, and wait for user input before heating or
cooling to current set-point.

Other manuals for Fluke 917 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluke 917 Series and is the answer not in the manual?

Fluke 917 Series Specifications

General IconGeneral
BrandFluke
Model917 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals