DSX CableAnalyzer
Users Manual
16
If the AC adapter is not connected, the red bar shows that
the battery is very low. Connect the AC adapter to charge
the battery and make sure the tester continues to operate.
The red bar also shows if the AC adapter is connected, but the
battery is not installed.
On a remote
The LEDs show the battery status at the end of the power-up
sequence, as shown in Figure 4.
GPU102.EPS
Figure 4. LEDs Show the Remote’s Battery Status
To see more information about the battery status
1 Make the connections shown in Figure 5 and turn on both
testers.
2 Tap TOOLS, then tap Battery Status.
84 % - 100 %
67 % - 83 %
51 % - 66 %
34 % - 50 %
18 % - 33 %
0 % - 17 %
riešenia na presné meranie
To Next Page
Loading...
