Fluke DTX-1200 - Memory Functions

Memory Functions
33
Memory Functions
All DTX testers have internal memory that can store at
least 250 Autotest results, including graphical data. The
maximum capacity of internal memory depends on the
space taken by the tester’s software.
The DTX-1800 and DTX-1200 testers can also store up to
500 Cat 6 Autotest results, including graphical data, on a
16 MB card. The testers can also use secure digital (SD)
memory cards.
Formatting the Memory Card (DTX-1800 and
DTX-1200)
To format the memory card turn the rotary switch to
SPECIAL FUNCTIONS, select Memory Status; then press
K Format.
Setting the Storage Location (DTX-1800 and
DTX-1200)
To set the destination for saved results turn the rotary
switch to SETUP, select Instrument Settings, select Result
Storage Location; then select Internal Memory or
Memory Card (if present).
Note
If you change the Result Storage Location, and
the selected Current Folder does not exist in the
new location, the tester creates a new folder
with the current folder’s name in the new
location.
Viewing Results
To view saved results, do the following:
1 Turn the rotary switch to SPECIAL FUNCTIONS; then
select View/Delete Results.
2 If necessary, press
J Change Folder to find the
result you want to view.
3 Highlight the result; then press
H.