Maintenance
45
Updating with a Memory Card (DTX-1800,
DTX-1200)
You can update the tester’s software using a memory
card that contains the software update file.
1 Download the DTX CableAnalyzer update file from
the Fluke Networks website, or contact Fluke
Networks to get the update by other means. You
can access the software page at
www.flukenetworks.com/support. Save the file to
your hard drive.
2 Copy the software update file to a memory card.
3 Connect the tester and smart remote together using
a permanent link and a channel adapter or two
channel adapters and a patch cord. Turn on the
tester and the smart remote.
4 Put the memory card in the tester.
5 Turn the rotary switch to SPECIAL FUNCTIONS; then
select Update Software.
6 Press
L Yes to start the update procedure.
7 When the tester is updated, it reboots, then prompts
you about updating the smart remote’s software.
Press
K OK to update the smart remote’s
software.
8 To verify the update, turn the rotary switch to
SPECIAL FUNCTIONS; then select Version
Information.
To Next Page
Loading...
