2
3R, 3G, 5R, 5G
Users Manual
• Do not alter the Product and use only as specied, or the protection supplied by the Product can be
compromised.
• Do not use the Product if it operates incorrectly.
• Do not use the Product if it is altered or damaged.
• Use the Product only as specied or hazardous laser radiation exposure can occur.
• Do not look into the laser. Do not point laser directly at persons or animals or indirectly o reective surfaces.
• Do not look directly into the laser with optical tools (for example, binoculars, telescopes, microscopes).
Optical tools can focus the laser and be dangerous to the eye.
• Do not open the Product. The laser beam is dangerous to eyes.
• Batteries contain hazardous chemicals that can cause burns or explode. If exposure to chemicals occurs,
clean with water and get medical aid.
• Do not disassemble the battery.
• Repair the Product before use if the battery leaks.
• The battery door must be closed and locked before you operate the Product.
• Remove the batteries if the Product is not used for an extended period of time, or if stored in temperatures
above 50 °C. If the batteries are not removed, battery leakage can damage the Product.
• Replace the batteries when the low battery indicator shows to prevent incorrect measurements.
• Be sure that the battery polarity is correct to prevent battery leakage.
• Use only Fluke approved power adapters to charge the battery.
• Do not short the battery terminals together.
• Do not disassemble or crush battery cells and battery packs.
• Do not keep cells or batteries in a container where the terminals can be shorted.
• Do not put battery cells and battery packs near heat or re. Do not put in sunlight.
Table 1 is a list of the symbols that can be used on the Product or in this manual.
Table 1. Symbols
Symbol Description Symbol Description
Consult user documentation.
P
Conforms to European Union directives.
W
WARNING. RISK OF
DANGER.
Conforms to relevant Australian Safety and EMC standards.
*
WARNING. LASER
RADIATION.
Risk of eye damage.
Conforms to relevant South Korean EMC Standards.
To Next Page
Loading...
Need help?
General
