Need help?Do you have a question about the Fluke 830 and is the answer not in the manual?
General| Laser Wavelength | 635 nm |
|---|---|
| IP Rating | IP54 |
| Laser Class | II |
| Leveling Range | ±4 degrees |
| Operating Temperature | 14°F to 122°F (-10°C to 50°C) |
| Battery Type | AA |
| Range | 30 m (100 ft) with detector |
| Accuracy | ±1/8 inch at 30 feet |
Describes the Fluke 830 Laser Alignment Tool and its features.
Provides contact information for Fluke customer support.
Lists all items included in the product package.
Details operating conditions, temperature, and environmental factors.
Provides guidelines for safe handling, storage, and maintenance.
Details key components like sensor, prism, and brackets.
Explains the product's power source and battery charging.
Guides on how to use the wireless module for data transfer.
Configures device, regional, and default parameters.
Options for setting up printers and printing configurations.
Explains file management, saving, and printing reports.
Step-by-step guide for initial product setup and preparation.
Instructions for inputting machine dimensions for alignment.
Details on performing measurements using the wireless module.
How to view and interpret alignment results and diagnose conditions.
Key preparations before starting horizontal machine alignment.
Details laser adjustment, measurements, and machine alignment steps.
Explains soft foot condition and its causes and correction.
Explains available measurement modes like Compass and Clock.
Covers extending measurement range and adjusting averaging.
Covers typical configuration, setup, and flange setup.
Steps to perform measurements and diagnose vertical machines.
Steps for correcting angularity and offset at the flange.
Instructions for connecting the sensor via cable and testing.
Guide for updating the product's and sensor's firmware.
Detailed specifications of the Fluke 830 Laser Alignment Tool.
To Next Page
