Fluke 830 - Handling Precautions

830
Users Manual
10
Handling precautions
The Product and its related components are precision instruments and should not
be dropped or subjected to physical shock.
Storage
Use the supplied case to transport the Product and its related components. If the
Product is not used for an extended period, remove the related batteries from the
components and store the components in a cool, dry and well-ventilated location.
Caution
Observe the storage temperatures and humidity specied in the techni-
cal data.
Care
All optical surfaces (prism, sensor lens) must be kept clean. Use only the
supplied lens cleaning cloth. Avoid vigorous polishing to preserve the anti-reec-
tive coatings of the glass elements. The housings of the Product, sensor, and
prism may be wiped clean using a soft cloth dampened with a mild, non-abrasive
detergent (use soapy water with only 1% mild soap in water). The display should
be cleaned using a soft dry cloth.
Maintenance
Although the Product and its related components are essentially maintenance-
free, the following points should be observed:
● The calibration accuracy of the sensor should be checked every two years.
● Please return the system components to your authorized service center for
calibration checking.
Warning
• Do not open the Product. The laser beam is dangerous to eyes. Have
the Product repaired only through an approved technical site.
• Use only specied replacement parts.
• Have an approved technician repair the Product
Caution
When returning the Product and its battery operated components for
calibration, service or repair, ensure that the batteries are not defec-
tive. If you suspect a defect in the battery, DO NOT ship the unit with the
defective battery. You may contact your local representative for further
information.