830
Users Manual
116
4. Press
ENTER
to take the rst measurement point.
Note
After taking measurement point, the clock hour hand moves automatically to
the next clock position. (If the rst measured position is 12:00 o’clock, then the
hour hand moves to the 1.30 o’clock position).
5. Rotate the shafts to the next measurement position (this could be either 1:30,
3.00, 4.30, 6.00, 7.30, 9.00 or 10.30 o’clock position).
Note
If shaft rotation restrictions hinder the taking of measurement at particular
shaft positions, bypass these using the navigation keys.
6. Press
ENTER
to take measurement point.
Note
A minimum of three measurement positions are required to obtain results, but
it is recommended that a maximum number of measurement points over a
wider rotational angle be taken to enhance the diagnosis.
To Next Page
Loading...
