Electrosurgery Analyzer
Safety Information
3
XW Warning
To prevent possible electrical shock, fire, or
personal injury, follow these guidelines:
• Read all safety information before you
use the Product.
• Use the Product only as specified, or the
protection supplied by the Product can
be compromised.
• Limit operation to the specified
measurement category, voltage, or
amperage ratings.
• Use the correct terminals, function, and
range for measurements.
• Carefully read all instructions.
• Do not touch voltages >30 V ac rms,
42 V ac peak, or 60 V dc.
• Do not use the Product around explosive
gas, vapor, or in damp or wet
environments.
• Do not use the Product if it operates
incorrectly.
• Examine the case before you use the
Product. Look for cracks or missing
plastic. Carefully look at the insulation
around the terminals.
• Do not use test leads if they are
damaged. Examine the test leads for
damaged insulation, exposed metal, or if
the wear indicator shows. Check test
lead continuity.
• Use this Product indoors only.
• Use only the mains power cord and
connector approved for the voltage and
plug configuration in your country and
rated for the Product.
• Make sure the ground conductor in the
mains power cord is connected to a
protective earth ground. Disruption of
the protective earth could put voltage on
the chassis that could cause death.
• Replace the mains power cord if the
insulation is damaged or if the insulation
shows signs of wear.
To Next Page
Loading...
Need help?
General
