QA-ES III
Getting Started Manual
4
• Use only current probes, test leads, and
adapters supplied with the Product.
• Connect the common test lead before
the live test lead and remove the live test
lead before the common test lead.
• Only use probes, test leads, and
accessories that have the same
measurement category, voltage, and
amperage ratings as the Product.
• Remove all probes, test leads, and
accessories that are not necessary for
the measurement.
• Do not connect measurement inputs
directly to mains.
• Do not use test leads if they are
damaged. Examine the test leads for
damaged insulation and measure a
known voltage.
• Disable the Product if it is damaged.
• Do not use the Product if it is damaged.
• Do not touch exposed metal on banana
plugs, they can have voltages that could
cause death.
• Remove circuit power before you
connect the Product in the circuit when
you measure current. Connect the
Product in series with the circuit.
• Connect an approved three-conductor
mains power cord to a grounded power
outlet.
• Do not put the Product where access to
the mains power cord is blocked.
• Make sure that the Product is grounded
before use.
• Do not put metal objects into
connectors.
• Make sure that the space around the
Product meets minimum requirements.
• Do not use the Analyzer in CAT II, III, or
IV environments.
• Retractable end of test leads are for use
on ESU only.
• No probes or accessories supplied with
the Analyzer are intended for handheld
use. Setup and stand clear when
activating the ESU with the footswitch.
To Next Page
Loading...
Need help?
General
