Need help?Do you have a question about the Fluke RUSKA 2456-LEM and is the answer not in the manual?
General| Model | 2456-LEM |
|---|---|
| Pressure Media | Clean, dry, non-corrosive gases |
| Display | LCD |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Resolution | 0.00001 psi |
| Operating Temperature | 18 °C to 28 °C |
| Outputs | RS-232 |
Describes the purpose and capabilities of the RUSKA 2456-LEM monitor.
Highlights warnings and cautions for safe operation and maintenance of the LEM.
Outlines the setup process for PC operation with LEMCal software.
Provides step-by-step instructions for installing the LEMCal software.
Covers initial configuration steps for the LEM software.
Guides on configuring serial port settings for communication.
Explains how to view and change the LEM's communication address.
Explains the address setting requirement for LEMCAL software.
Describes how to choose local or remote pressure sources in the software.
Details how to select preferred units for environmental parameters.
Introduces setting upper and lower limits for parameters.
Guides on setting parameter limits, alarms, and copying values.
Introduces password protection for calibration and program exit.
Describes how to view live sensor readings on the main screen.
Explains the function of capturing sensor data over time.
Details the data logging screen, module enablement, and intervals.
Explains the need for unique addresses for multiple LEMs on a bus.
Guides on setting up remote pressure source configuration.
Details setup for using external pressure gauges with the LEM.
Details calibration points for pressure sensors.
Details calibration points for temperature sensors.
Explains the process of zeroing the sensor for accuracy.
Details calibration points for humidity sensors.
Presents the formula and conditions for LEM's direct air density calculation.
Lists operating ranges and performance specifications for temperature, pressure, and humidity.
Introduces the two general standards for remote communication.
Describes the command to set or change the LEM's address.
To Next Page
