Fluke ScopeMeter 190 II Series - Page 188

Fluke 190-062, -102, -104, -202, -204, -502, -504
Service Manual

 3UHVV
F2

7KHWHVWSDWWHUQLVUHPRYHGDQGWKH7HVW7RROVKRZV
Contrast (CL 0110):
 3UHVV
F2
DJDLQWRGRWKHQH[WVWHSContrast (CL 0120):
 3UHVV
F3
&$/,%5$7(
7KH7HVW7RROVKRZVDOLJKWGLVSOD\7KHWHVWSDWWHUQVKRZQLQ)LJXUH
PD\QRWEHYLVLEOHRUKDUGO\YLVLEOH
2EVHUYHWKHGLVSOD\FORVHO\DQGYHULI\WKDWWKHGLVSOD\VKRZVQR
DEQRUPDOLWLHV
 7XUQRIIDQGWXUQRQWKH7HVW7RROWRH[LWWKHFDOLEUDWLRQPHQXDQGUHWXUQWR
WKHQRUPDORSHUDWLQJPRGH
,IWKHPD[LPXPPLQLPXPRUGHIDXOWGLVSOD\FRQWUDVWLVQRW2.WKHQ\RXFDQ
DGMXVWWKHVHLWHPVZLWKRXWSHUIRUPLQJDFRPSOHWHFDOLEUDWLRQDGMXVWPHQWUHIHUWR
6HFWLRQIRUGHWDLOHGLQIRUPDWLRQ
Scope Input A, B, C, D Tests
Input A, B, C, D Vertical Accuracy Test
 Warning
To prevent possible electrical shock, fire, or personal injury,
ensure that the calibrator is in standby mode before making any
connection between the calibrator and the Test Tool.
Dangerous voltages are present on the calibration source and
connection cables during these steps.
Note
The test steps for channels C and D are only for the models
190-104, 190-204, or 190-504.
3URFHHGDVIROORZV
 &RQQHFWWKH7HVW7RROWRWKH$DVVKRZQLQ)LJXUH7KHYHUWLFDO
FKDQQHOV$%&DQG'DUHFKHFNHGLQVXFFHVVLRQVRWKDWWKHUHLVRQH
ZDYHIRUPRQWKHGLVSOD\DWDWLPHWRIDFLOLWDWHDPSOLWXGHDGMXVWPHQW