Fluke ScopeMeter 190 II Series - Using the Tilt Stand

ScopeMeter® Test Tool 190 Series II
Users Manual

ANALOG INPUT DIGITAL CONTROLLER
$1$/2*
*5281'
',*,7$/
*5281'
A
D
Figure 43. Wrong connection of reference leads
1RLVHWKDWLVSLFNHGXSE\UHIHUHQFHOHDG'FDQEH
WUDQVPLWWHGE\SDUDVLWLFFDSDFLWDQFHWRWKHDQDORJLQSXW
DPSOLILHU
Using the Tilt Stand
7KHWHVWWRROLVHTXLSSHGZLWKDWLOWVWDQGDOORZLQJYLHZLQJ
IURPDQDQJOHZKLOHSODFHGRQDWDEOH7KHW\SLFDOSRVLWLRQ
LVVKRZQLQ)LJXUH
.HQVLQJWRQ ORFN
VXSSRUW

3RZHUDGDSWHULQSXW
Figure 44. Using the Tilt Stand
Note
An optional Hanging Hook, ordering code HH290,
can be attached to the rear of the test tool. The
hook enables you to hang the test tool at a
convenient viewing position, for example a
cabinet door or a separation wall.