Fluke ScopeMeter 190 II Series - Page 240

Fluke 190-062, -102, -104, -202, -204, -502, -504
Service Manual

Input AB Position
7RGRWKH,QSXW$%3RVLWLRQFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWFDOLEUDWLRQDGMXVWPHQWVWHSCL 0637 3RV$%
 5HPRYHDOO,QSXW$%FRQQHFWLRQVRSHQLQSXWV
 3UHVV
F3
WRVWDUWWKHFDOLEUDWLRQ
 :DLWXQWLOWKHGLVSOD\VKRZVFDOLEUDWLRQVWDWXV
:READY
 &RQWLQXHDWWKHInput AB LF-HF Gain and Position VHFWLRQ
Input AB LF-HF Gain and Position
7RGRWKH,QSXW$%/)+)*DLQFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWWKHILUVWFDOLEUDWLRQVWHSLQ7DEOHIRUWKH
VXEYHUVLRQ
 &RQQHFW&K$DQG%RIWKH7HVW7RROWRWKH$DVVKRZQLQ)LJXUH
NORMAL SCOPE
FLUKE 5502A CALIBRATOR
CONNECT TO CHANNEL A, B, C, D IN PARALLEL
50 OHM TERMINATIONNO
ADC
B
PM9093
PM9092
AB
METER
P
M
9
0
9
3
PM9092
PM9091
2 CHANN. + METER
4 CHANNELS
SHUIYHUFHSV
Figure 5-7. Test Tool Input ABCD to 5502A SCOPE Output
 6HWWKH$WRVXSSO\DN+]VTXDUHZDYH6&23(02'(YROW6&23(
=07RIP9WRFKDQQHO$DQG%
 Warning
To prevent possible electrical shock, fire, or personal injury,
ensure that the calibrator is in standby mode before making any
connection between the calibrator and the Test Tool.
Dangerous voltages are present on the calibration source and
connection cables during these steps.
 6HWWKH$WRRSHUDWH235
 3UHVV
F3
WRVWDUWWKHFDOLEUDWLRQ
 :DLWXQWLOWKHGLVSOD\VKRZVFDOLEUDWLRQVWDWXV
:READY