Fluke ScopeMeter 190 II Series - Page 244

Fluke 190-062, -102, -104, -202, -204, -502, -504
Service Manual

Multimeter Meter Zero
Note
The adjustment steps for the meter section are only for the models
190-062, 190-102, and 190-202. For 4-Channel ScopeMeters, go to
the 6DYH&DOLEUDWLRQ'DWDDQG([LWsection.
3URFHHGDVIROORZVWRGRWKH0XOWLPHWHU'00=HURFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWFDOLEUDWLRQDGMXVWPHQWVWHS&/
 6KRUWFLUFXLWLQWHUFRQQHFWWKHEDQDQDMDFN0HWHULQSXWV8VHDWHVWOHDGas
short as possible
 3UHVV
F3
WRVWDUWWKH]HURFDOLEUDWLRQ
 :DLWXQWLOWKHGLVSOD\VKRZVWKHVWDWXV
:READY
 5HPRYHWKHLQSXWWHUPLQDWLRQV
 &RQWLQXHDWWKHMultimeter (DMM) Volt Gain VHFWLRQ
Multimeter Volt Gain
 Warning
To prevent possible electrical shock, fire, or personal injury,
ensure that the calibrator is in standby mode before making any
connection between the calibrator and the Test Tool.
Dangerous voltages are present on the calibration source and
connection cables during these steps.
Note
The adjustment steps for the meter section are only for the models
190-062, 190-102, 190-202, and 190-502.
7RGRWKH'009ROW*DLQFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWWKHILUVWFDOLEUDWLRQVWHSLQ7DEOH
 &RQQHFWWKH7HVW7RROWRWKH$DVVKRZQLQ)LJXUH