Fluke ScopeMeter 190 II Series - Page 255

Calibration Adjustment
Final Calibration (Firmware: V10.9 and Lower) 

Input D LF-HF Gain
Note
The adjustment steps for channel D are only for the models 190-104
and 190-204.
7RGRWKH,QSXW'/)+)*DLQFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWWKHILUVWFDOLEUDWLRQVWHSLQ7DEOH
 &RQQHFWWKH7HVW7RROWRWKH$DVVKRZQLQ)LJXUH
ADC
B
NORMAL
SCOPE
FLUKE 5502A CALIBRATOR
PM9091
PM9585 - 50 OHM
USE 50 OHM
TERMINATION
4 CHANNELS
For 190-502 and -504
use only TRM50!
3HUI9HU*HSV
Figure 5-14. 5502A SCOPE Output to Test Tool Input D
 6HWWKH$6&23(RXWSXWWRVRXUFHWKHVLJQDOUHTXLUHGIRUWKHILUVW
FDOLEUDWLRQSRLQWLQ7DEOH
 6HWWKH$LQRSHUDWH235RUVWDQGE\67%<DVLQGLFDWHG
 3UHVV
F3
WRVWDUWWKHFDOLEUDWLRQ
 :DLWXQWLOWKHGLVSOD\VKRZVFDOLEUDWLRQVWDWXV
:READY
 3UHVV
F2
WRVHOHFWWKHQH[WFDOLEUDWLRQVWHSVHWWKH$WRWKHQH[W
FDOLEUDWLRQSRLQWVLJQDODQGVWDUWWKHFDOLEUDWLRQ
&RQWLQXHWKURXJKDOOFDOLEUDWLRQSRLQWVRI7DEOHDQG7DEOH
 :KHQ\RXDUHILQLVKHGVHWWKH$WR6WDQGE\
 &RQWLQXHDWWKHInput ABCD (AB) LF-HF Gain VHFWLRQ.