Fluke ScopeMeter 190 II Series - Page 261

Calibration Adjustment
Final Calibration (Firmware: V10.9 and Lower) 

Table 5-19. DMM Gain Calibration Points
Cal step UUT input value (5502A NORMAL)
&/ P9
&/ 9
&/ 9
&/ 9 VHW$WR235
&/ 9
&/ 9
Multimeter Numeric Zero
Note
The adjustment steps for the meter section are only for the models
190-062, 190-102, and 190-202.
7RGRWKH0XOWLPHWHU'00=HURFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWFDOLEUDWLRQDGMXVWPHQWVWHS&/
 6KRUWFLUFXLWWKHEDQDQDMDFN0HWHULQSXWVSURSHUO\FDOLEUDWLRQLQFOXGHV
2KPV]HUR8VHDWHVWOHDGDVVKRUWDVSRVVLEOH
 3UHVV
F3
WRVWDUWWKH]HURFDOLEUDWLRQ
 :DLWXQWLOWKHGLVSOD\VKRZVWKHVWDWXV
:READY
 5HPRYHWKHLQSXWWHUPLQDWLRQV
 &RQWLQXHDWWKHMultimeter (DMM) Ohm Gain VHFWLRQ
Multimeter Ohm Gain
Note
The adjustment steps for the meter section are only for the models
190-062, 190-102, and 190-202.
7RGRWKH'002KP*DLQFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWWKHILUVWFDOLEUDWLRQDGMXVWPHQWVWHSLQ7DEOH
 &RQQHFWWKH7HVW7RROWRWKH$DVVKRZQLQ)LJXUH1RWLFHWKDWWKH
VHQVHOHDGVPXVWEHFRQQHFWHGGLUHFWO\WRWKH7HVW7RRO