Fluke ScopeMeter 190 II Series - Page 263

Calibration Adjustment
Save Calibration Data and Exit 

Save Calibration Data and Exit
7RVDYHWKHFDOLEUDWLRQGDWDDQGH[LWWKH0DLQWHQDQFHPRGH
 5HPRYHDOOWHVWOHDGVIURPWKH7HVW7RROLQSXWV
2. 3UHVV
F4
EXIT)7KH7HVW7RROVKRZVRQWKHGLVSOD\
Calibration data valid.
Save data and exit maintenance mode?
Note
Calibration data valid indicates that the calibration adjustment
procedure is performed correctly. It does not necessarily mean that
the Test Tool meets the specifications listed in Chapter 2.
 3UHVV
F4
YES)WRVDYHDQGH[LW
Note
After saving the calibration data, the calibration number and date updates if
the calibration data changes and the data are valid.
The calibration number and date do not change if:
v the calibration m
ode is entered and left without doing a calibration
adjustment.
v only the contrast calibration adjustment and/or the probe calibration are
done.
If you press
F3
12, the Test Tool returns to the calibration mode.
You can either calibrate the Test Tool again, or press
F4
(;,7,
F4
<(6 to save and exit.
Error messages:
WARNING: Calibration data not valid.
Save data and exit maintenance mode?
,I\RXGLGWKH:DUPLQJ8SDQG3UH&DOLEUDWLRQVXFFHVVIXOO\DQG\RXZDQWWR
VWRUHWKH3UH&DOLEUDWLRQGDWDEHIRUHFRQWLQXLQJZLWKWKH)LQDO&DOLEUDWLRQ
 3UHVV
F4
<(6
:KHQ\RXWXUQRIIDQGWXUQRQWKH7HVW7RRODJDLQLWZLOOVKRZWKHPHVVDJH
The instrument needs calibration.
Please contact your service center.
7KHFDOLEUDWLRQGDWHDQGQXPEHUGRQRWXSGDWH<RXPXVWFRQWLQXHZLWKWKH
)LQDO&DOLEUDWLRQ
7RUHWXUQWRWKH0DLQWHQDQFHPRGHDQGUHSHDWWKHFRPSOHWHFDOLEUDWLRQ
 3UHVV
F3
12
 3UHVV
F1
XQWLOWKHGLVSOD\VKRZVWarmingUp (CL 0200):IDLEDQG
FDOLEUDWHWKH7HVW7RROVWDUWLQJDWWarming-Up and Pre-Calibration
,I\RXZDQWWRH[LWDQGPDLQWDLQWKHROGFDOLEUDWLRQGDWD
 7XUQWKH7HVW7RRORII