T+/T+PRO English Instruction Sheet
Page 11
Measuring Resistance (T+ PRO Only)
XWWarning
To avoid electrical shock when measuring resistance
in a circuit, make sure the power to the circuit is
turned off and all capacitors are discharged.
To measure resistance, turn off the circuit power, press O, and
place the test probes across the resistance under test. For
resistances less than 9.99 kΩ, the T+PRO display shows the
resistance value. For greater resistances, the display shows OL.
See Figure 4.
DISPLAY ON >10V
eqc04f.eps
Figure 4. Measuring Resistance
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca