July 2007 Rev. 1, 9/17
© 2007-2017 Fluke Corporation, All rights reserved. Printed in USA.
All product names are trademarks of their respective companies.
1
T+ and T+ PRO
Electrical Tester
Calibration Information
Introduction
This document provides the following information for the T+ and T+ PRO Electrical Testers
(hereafter referred to as the “Tester” or UUT):
• Safety information
• Symbols
• Contacting Fluke
• Specifications
• Maintenance
• Performance tests
• Parts and accessories list
• Product Warranty Statement
For complete operating instructions, refer to the T+ and T+ PRO Instruction Sheet.
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user. A Caution
identifies conditions and procedures that can cause damage to the Product or the equipment under
test.
XWWarning
To avoid possible electric shock or personal injury, follow these
guidelines:
• Use the Tester only as specified in this document, otherwise
the protection provided by the Tester may be impaired.
• The Tester is to be used only by qualified personnel.
• Do not use the Tester if it is damaged. Inspect the case
before use. Look for cracks or missing plastic. Pay particular
attention to the insulation surrounding the connectors.
• Inspect the test leads for damaged insulation or exposed
metal. Check the test leads for continuity. Replace damaged
test leads before using the Tester.
To Next Page
Need help?
General
