T+/T+PRO English Instruction Sheet
Page 3
• When using the probes, keep fingers away from
the ends of the probe tips.
• Connect the common test lead before
connecting the live test lead. When
disconnecting the test leads, disconnect the live
test lead first.
• Do not operate the Tester with the battery door
or portions of the cover removed or loosened.
• When the batteries are depleted, self test will not
function.
• When the beeper is disabled, it will not sound
until the beeper is reactivated.
• For voltages above 240 V, you must only connect
to a voltage source for a MAXIMUM of 30s and
then disconnect for a MINIMUM of 300s.
• Perform a self test before any measurements are
taken for voltage, continuity, resistance, or
rotary field. See “Self Test”.
• Exercise caution when performing
measurements on PLC (Programmable Logical
Controller) inputs. When measuring relay control
voltages on PLCs, be aware that this may open
or close the relay/switch.
• All appliances or equipment on the circuit being
tested should be unplugged to help avoid
erroneous readings.
WCaution
Although the Tester may be used with depleted batteries,
replace depleted batteries immediately to avoid Tester
damage from battery acid leakage.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca
To Next Page
Loading...
Need help?
General
