Fluke VT02 - Auto-Monitor Alarm (VT04 A, VT04)

VT02, VT04A, VT04
Users Manual
22
Auto-Monitor Alarm (VT04A, VT04)
The Auto-Monitor Alarm feature is similar to the high/low temperature alarm
feature. The difference is that instead of a flashing warning, the Product saves
an image. When the temperature of an object in the scene goes above or below
the threshold value, the Product saves the image.
By default, the file name for these captured images includes an A, for example,
XXXA.is2.
Note
Measurements are the scene temperature (area shown inside the
markers).
To set the Auto-Monitor Alarm:
(-10 °C to +250 °C)
(15 min, 30 min,
1 hr, 2 hr, 4 hr, 8 hr)
To stop the Auto-Monitor Alarm:
Note
• The Auto Off feature is disabled in the Auto-Monitor Alarm
mode.
• The Auto-Monitor Alarm feature is disabled when the Product
is connected to power.