(Pic 21.58)
(Pic 21.59)
Speed sensor:
Select the rotation speed sensor to use. If none is selected, this function is disabled.
Set rotation length:
Set the model travel distance corresponding to one rotation speed sensor. This distance is
used to control the virtual speed and odometers sensors.
Touch "Set rotation length" to set distance traveled by the model in one revolution of wheel
(Unit: mm), As shown in Picture 21.59, touch back button to return.
(Pic 21.60)
Reset odometer:
Touch "Reset odometer 1” or “Reset odometer 2" to reset the corresponding odometer.
Odometer 1: It is used for recording the distance traveled by the vehicle one time.
Odometer 2: It is used for recording total distance traveled by the vehicle.
http://www.flysky-cn.com
44
To Next Page
Loading...
