DISPLAY, SYMBOLS AND UNITS
Display, symbols and units
The display contains three symbols, five units, three bigand two small digits.
The small digits show the window number in the menu structure. The big digits show a
value. If the value is greater than three digits the two small digits alternate between the
window number and the first two digits in the value.
Example: The total pumping time (window 07) is 13467 hours. Window number 07 is
displayed for 2 sec and then 13467 is displayed for 2 sec.
Symbol Meaning
Alarm
Time value
Parameter lock
Unit Meaning
V Volt
mA Milli-ampere
m Minutes
S Seconds
% Percent
Note 1: When FPC100 is turned on, a self test is performed during 3 seconds and all
characters and symbols on the display are shown.
Note 2: During alarm the entire display is flashing.
Note 3: If “oor” (out of range) is shown on the display, it means that the value is too big to
be shown on the display.
DISPLAY, SYMBOLS AND UNITS
10 Single pump controller Installation and user manual for FPC100
To Next Page
Loading...
Need help?
General
