Need help?Do you have a question about the FLYGT CAS and is the answer not in the manual?
General| Brand | FLYGT |
|---|---|
| Model | CAS |
| Category | Controller |
| Language | English |
Connect power supply, interlock circuit, and jumpers as per diagram.
Use a multimeter, check supply voltage limits, and refer to service shop if issues persist.
Verify pilot lamp 61 and voltage between terminals 14 and 16.
Check voltage on terminals 17/18, pilot lamp 51, and A-alarm activation.
Check voltage on terminals 19/20, pilot lamp 52, B-alarm activation, and reset.
Check sensor disconnection, C-alarm activation, and manual reset capability.
Test manual reset with specific resistors between terminals 26 and 27.
To Next Page
